Saturday 28 November 2015

New in 2016

 From Arp2500, this is based on the 1006 Filtamp, minus the amp.....it is squirty
 The Giant Bono - a delay chip & a PLL with 2 vactrols.........just crap!
based on the ARP 1050 Mix-Sequencer, minus the switches and VCO. It is a standard 8 stage sequencer, or two four stage sequencers, or an 8 stage sequential switch, or two 4 stage sequential switches (good for routing audio and/or CV), or an 8 input mixer, or two 4 input mixers (with an 8 input output anyway) and there is a difference rectifier in there giving the positive and negative results of the difference between stages (1-4) and stages (5-8).
Also the LEDs spin around in a circle giving a nice light show.
16HP, no wiring, all smd.
There's actually not that many parts, the logic chips do all the work

Phaser/Flanger based on the Aries 329. It has 11 matched NPN pairs and a set of matched FETs. It is actually quite simple to match FETs, a circuit will be given in the build guide. Pretty much all surface mount.

FK1t VCF - inspired by the Korg FK-1 pedal. It has a similar topology to the early Korg filters found in the 700 and 800dv synths but uses vactrols. What could go wrong?

2 comments:

  1. Bono and the Sequencer/Mixer for me.

    ReplyDelete
  2. As soon as I get a job I'm all over this stuff! Been fancying some of your modules for a while and I think 2016 is going to be the year when I finally get some.

    ReplyDelete

Note: only a member of this blog may post a comment.